Continuous Monitor, One Operator, Universal Adapter

The Desco Multi-Mount Monitor is a single workstation continuous monitor. It continuously monitors the path-to-ground integrity of one operator and one ESD worksurface. Mounting tabs make it suitable to install in workbench or equipment settings. Connect the 19653 Remote Alarm accessory to the
Multi-Mount Monitor, and place it in the operator's field of view for increased alarm visibility.
The Multi-Mount Monitor is designed with Wave Distortion Technology which provides stable continuous monitoring of the path-to-ground and presence of 1megohm resistance of an operator’s wrist strap. Audio and visual alarms activate (in less than 50 milliseconds) when the operator unintentionally
disconnects from the monitor or the wrist strap connection points are intermittent. The Multi-Mount Monitor also monitors for a worksurface path-to-ground of less than 10 megohms. All Multi-Mount Monitors are calibrated to NISTstandards and include a certificate.
Was CP50391 and DES19236

* Single Workstation Continuous Monitor
Continuously monitors the path-to-ground integrity of one operator and one ESD worksurface
*IMPROVED Operator Alarm
Alarms when the operator unintentionally disconnects from the monitor or the connection between the banana plug and monitor’s jack is intermittent
* NEW Mat Monitor Switch
Disables the worksurface monitor circuit when used in areas where there is no ESD worksurface
* NEW Audible Alarm Adjustment
Sets the audible alarm volume from loud to louder
* NEW 19653 Remote Alarm Accessory
Connect to the Multi-Mount Monitor and place in the operator’s field of view to alert operator of alarms
* Desco Wave Distortion Technology
Provides stable continuous monitoring (versus pulsed or intermittent) of the wrist strap’s path-to-ground* and the presence of its 1 megohm safety resistor
* Park Snap
Allows the operator to disconnect (and park) a wrist strap when leaving the workstation without creating a false alarm
* Single-Wire Impedance Design
Meets ANSI/ESD S20.20 in accordance with ESD TR1.0-01-0
* 1.2 Volt Operator Test Voltage
Reduces the risk of electrical overstress (EOS) for the handling of sensitive components
* <50 Millisecond Alarm Response Time
Identifies failures and intermittencies that inferior technologies miss
* Continuous Visual and Audible Alarms
Illuminates green to indicate proper grounding; illuminates red and sounds audible alarm when intermittent or failed connection occurs
* Calibration Verification
Use the Desco 98221 Wave Distortion Monitor Verification Tester to check the test limits of Wave Distortion Monitors without removing them from their workstations
* NIST Calibrated with Certificate Included
Calibrated with accepted procedures and standards traceable to the National Institute of Standards and Technology. For more information on the calibration of Desco products, see Calibration.
* 100-240VAC Power Adapter with IEC C14 Style Inlet
Connects to a power cord with a IEC C13 outlet connector
* Made in the United States of America

1 Multi-Mount Monitor
1 Mat Monitor Cord (White)
1 Countersunk Washer
1 Flat Head Screw, 6-32 x 1/4"
2 Pan-Head Screws, 6 x 3/8"
1 Dual Lock Fastener Set, 2" Length
1 10mm Interchangeable Park Snap
1 10mm Operator Jack Adapter
1 Power Adapter, 24VDC, IEC Inlet
1 Certificate of Calibration

Does not include wrist strap. Wrist Strap to be purchased seperately.

DES19652 TDS.